View Cart
Too much iron in your water?
- Filters iron and manganese to stop rust stains on your showers, sinks, and tubs
- Protects major appliances like water heaters, dishwashers, and washing machines from rust
- Filters hydrogen sulfide (rotten egg smell) from your water
- Radial flow design gives high flow rate and low pressure drop
- Simple maintenance, just replace the cartridge, no chemical back-flushing
- Economical solution for moderate levels of iron (<5 ppm)
AQUASANA® EQ-300IP Water Filter Features
- Filters iron from your water at a fraction of the cost of other systems
- Uses manganese greensand to oxidize and filter iron, manganese, and hydrogen sulfide (rotten egg smell)
- Remains effective across a wide pH range
- No media regeneration or back washing that can harm septic systems
- Does not add harmful byproducts to your drinking water or to the environment via chemical back flushing
- Long filter life at moderate iron levels
- Space-saving design saves floor space, only 8 inches by 24 inches
- Includes filter wrench for easier cartridge changes
- Full 90 day, 100% Satisfaction Guarantee
AQUASANA EQ-300IP Cartridge Life
The EQ-300IP filer cartridge life varies with the amount of iron and manganese in your water:
- At 1 PPM, cartridges last up to 18 months
- At 3 PPM, cartridges last up to 6 months
- At 4.5 PPM, cartridges last up to 3 months
- Above 5 PPM, a water softener or regenerating iron removal system is needed
For low to moderate levels of iron, this is a very cost-effective solution.
EQ-300IP Whole House Iron Filter Installation
The EQ-300IP whole house filter is installed before another whole house filter, such as the RHINO EQ-300. This greatly increases the life of your primary whole house water filter.
The EQ-300IP is installed near the water's point of entry to your home, before the hot and cold water "split."
Installation by a licensed plumber is strongly recommended, because leaks near the point of entry can cause substantial damage to your home.
Easy Maintenance: Changing the Cartridge
The EQ-300IP filter cartridge should be replaced every 1-6 months, depending on the amount of iron in the water source (see above).
If you'd like to check whether the cartridge needs to be replaced, low cost drinking water iron tests are available.
To replace the EQ-300IP filter cartridge:
- Turn off the water supply
- Relieve pressure in the water system by opening a faucet near the unit
- Place a bucket under the filter housing
- Press the pressure release button on top of the filter housing to relieve any remaining water pressure
- Unscrew the filter housing
- Remove the old filter cartridge
- Wash out the filter housing as needed to remove any accumulation of debris
- Clean the housing o-ring and lubricate it with petroleum jelly
- Insert the new filter cartridge into the housing
- Screw the filter housing back on
- Slowly turn on the water supply valve and check for leaks
- In case of leaks, tighten connections or clean and reseat the o-ring
EQ-300IP Filter Replacement Cartridges
The EQ-300IP whole house filter comes with a cartridge installed in the housing. Additional replacement cartridges can be ordered by clicking on the picture or link below.
